BIOS assisted raid

Thad Van Ry thad at linuxnetadmin.com
Tue Dec 5 11:04:06 MST 2006


On 12/5/06, Brian Hawkins <brianhks at activeclickweb.com> wrote:
> The first time I installed I just went with the system default setup.
> It put /boot on the PATA drive and then created a logical volume out of
> the two SATA drives.  This seemed to work except there was no indication
> anywhere that it was setup as RAID 0 or that it was using the raid I
> setup in the BIOS.
>
Just FYI, LVM uses striping by default. Thus just LVM not on top of
RAID0 will still get you a performance gain.

-- 
Thad Van Ry
Woods Cross, Utah
http://woodscross.blogspot.com



More information about the PLUG mailing list